Call now to get tree helping suchlike tree clearance, tree remove, bush chop, shrub clean, stump lopping and bunch more around United States:


Call us

Call us +1 (855) 280-15-30






Highly recommend for anyone looking to save time.

SST - Extension Housing Bushing Driver / Installer and Removal Kit Easy removal and installation of the extension housing bushing, without removing the extension housing. For use on these Transmissions: GM,R, GM Borg-Warner T5 (Tremtec T-5)(World-Class T-5) Dimensions of tool for possible removal on other transmissions/5(12).

May 11, This tool is a JTA,"Universal transmission extension housing bushing tool". These kinds of tools are also called an"output shaft bushing tool". The silver and gold pieces on the right are for other transmissions, the black one on the tool itself is for the AODE and the T5.

This pic is of the assembled treefalling.buzzted Reading Time: 6 mins. Apr 10, I need to replace the bushing in the tailshaft of my T-5 as I have a leaky seal and vibrations. I'm not quite skilled enough yet to drop the transmission and take the tailshaft off, and no show near me had the tool.

They all just want to do a full rebuild. Does anyone have this tool? I would be willing to pay shipping and throw 30 bucks your treefalling.buzzted Reading Time: 6 mins. Nov 29, Yes - IF you can find someone who has the special tool (GOOD LUCK!), there is a T5 bushing r&r tool that will work with the transmission assembled and in the car. Sorta - leave the transmission in the car, but remove just the tailshaft.

With the right size bushing press you can remove the old and install the treefalling.buzzted Reading Time: 2 mins. Feb 20, Tail up, remove the seal. Place the INNER RACE salvaged from a T-5 Counter Shaft Bearing with the small side against the bushing. Put a large flat washer across the outer lip and press, or hammer the bushing deeper into the tail housing using the T-5 race as a pressing tool. This will BREAK LOOSE the bushing and you can then use a punch or dull.

Apr 30, Bloomington, MN. KD Tools makes a tool for this. (#) (Don't know if it's still available or not. I got one on ebay years ago.) You can use it to pull and replace the tail shaft bushing. Makes it a 5 minute job. maverick said: reeds rental stump grinder, 2482 Wellesley MA the tailshaft in a degree oven & the bushing in the freezerthe coefficient of thermal expansion is.

May 15, Discussion Starter #1 May 14, Need to remove the tailshaft bushing on a Nash 4+1 trans without removing the trans from the car. Looking to buy/rent the bushing removal tool (Snap on # S). Anyone have any leads on getting this tool or any other way of removing the bushing. Note this trans uses the large bushing (just under 2.

Dec 11, Trophy Points: Location: Opelousas La. It's just as easy to remove the tailshaft housing from the transmission and remove the bushing standing up, instead of laying under the car.

Last one I did, all I used was a screw driver and hammer to remove it, once it was out of the car. Come think of it, I don't see how either of those tools. Mar 04, T5 Tailshaft bushing repair. Jump to Latest Follow 1 - 3 of 3 Posts. R It can be done as long as you have some kind of tool to push it back in over the output shaft. A special tool was made at one time to remove/install the bush, but I was unsuccessful in trying to locate it.

I ended up pulling the tailshaft off and pressing it in.